How to Use a Craftsman Air Compressor

No garage would be complete without an air compressor. The electric motor of the compressor to maintain the air pressure in the air tank to run a variety of different air tools, including nail guns, impact wrenches, and spray paint. By connecting a gas compressor chuck, you can check and add air to your tires, eliminating the need to frequently visit the service station. Craftsman air compressor reviews are sold and served at most Sears stores.

how-to-use-a-craftsman-air-compressor

Place compressor on a flat work area firmly. Make sure the power switch is turned off. Put the plug in a base (three-pronged) electrical outlet.

Make sure there is enough oil in the crankcase. Check the oil level by looking at the gauge at the bottom of vision of the motor compressor. Remove the extra oil cap and add oil compressor to bring the level up to the mark complete on the meter. Check the oil level after every use.

Make sure the drain valve is closed at the bottom of the air tank by tightening it with a wrench and adjust clockwise. Turn the power switch on and allow the compressor to run for a few minutes. Check gauge built in and ensure the closure of the compressor automatically when the air pressure reaches 100-115 pounds per square inch.

Adjust the air control valve to match the air pressure the maximum allowed on the air tools that you will use. Do this by turning the air control valve in either direction until the air pressure gauge reading accurate air pressure for the tool.

Connect a compressed air line long enough to reach the work area. Wrap the threaded end of the air hose with two layers of Teflon tape. Pierced pipe fittings on the air compressor (located close to the air pressure gauge) and tighten it in a clockwise direction with an adjustable wrench.

Connect the air tool of your choice to the other end of the tube atmosphere by using suitable quick connections. Pull back on the collar spring loaded into the tube and push it into the engine air intake. Drop collar to secure the connection. To disconnect the engine, pull back on the collar when pulling gas pipeline from the tool.

Discharge moisture from air tank periodically (see the instructions of your Craftsman owners) by loosening and removing the drain valve at the bottom of the tank with an adjustable wrench in a clockwise opposite direction. When all the water has escaped tank drain valve replacement and tighten it in a clockwise direction.

Suggestions:

Always use eye protection when using air tools. Use ear protection if you will be working around the air compressor for long periods of time.

Never leave the air compressor on if left unattended. If the compressor does not shut down automatically when the air pressure gauge reaches 115 pounds per square inch, unplug the compressor and service it before using the air compressor. The cylinders can burst from excess air pressure.

More information here.

Leave a Reply

Your email address will not be published. Required fields are marked *